What does a metric of 16 hops represent when using RIP? A.) Number of hops to the destination B.) Destination unreachable C.) Number of routers D.) Bandwidth

3 Answers  

---

What do you use the Aux port for? A.) Console B.) Terminal editing C.) Modem D.) Backup logging

3 Answers  

---

What information is provided by the local management interface (LMI)? A.) LMI encapsulation type B.) The current DLCI values C.) The status of virtual circuits D.) The global or local significance of the DLCI values

1 Answers  

---

What is an advantage of UDP? Low Overhead High Overhead Reliable Not reliable

4 Answers  

---

The following selections show the command prompt and the configuration of the IP network mask. Which two are correct? A. Router#term IP netmask-format { bitcount | decimal | hexadecimal } B. Router(config-if)#IP netmask-format { bitcount | decimal | hexadecimal } C. Router(config-if)#netmask-format { bitcount | decimal | hexadecimal } D. Router#ip netmask-format { bitcount | decimal | hexadecimal }

2 Answers  

---

You just entered the following command_Router(config#) line console 0 Which operation is most likely to follow? A. Confound terminal type B. enter protocol parameters for a serial line C. create a password on the console terminal line D. establish a terminal type 4 connection to a remote host E. change from configuration mode to console privileged mode

10 Answers   Intel, Quark, Wipro,

---

Your network uses a Class C address of 210.10.10.0. You must now split up the network into separate shores to handle multiple buildings separated by routers. Which two steps must you take to determine the proper shored mask for your networks? (Choose two) A. determine the number of seperate networks required B. determine how many devices will require DHCP addressing C. determine the maximum number of hosts that will be on each shored D. determine the miniumum number of hosts that will be on each shored E. determine which router will be the IP default gateway for each shored

1 Answers  

---

Which configuration mode and command combination sets the bandwidth metric of a Frame Relay connection? A. router(config)# clock rate 56 B. router(config)# bandwidth 56 C. router(config)# bandwidth 56000 D. router(config)# clock rate 56000

2 Answers  

---

Identify the command that configures serial0 for PPP encapsulation? A.) Router(config)# encapsulation ppp B.) Router(config-if)# encapsulation serial ppp C.) Router(config-if)# encapsulation ppp D.) Router# encapsulation ppp

2 Answers  

---

How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

2 Answers  

---

Which OSI layer provides best effort end to end packet delivery? A.) Data-Link B.) Presentation C.) Network D.) Transport E.) Physical F.) Application

3 Answers   Barnes and Noble,

---

Which layer called error detection layer?

0 Answers  

---