If there is only 2 host in bus topology is that possible collision accord?

0 Answers  

---

Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols

3 Answers  

---

what is native vlan any one explain sooraj

7 Answers   IBM,

---

Identify the effect of Ctrl-Z? A.) Exits back to privileged exec mode B.) Disconnect from the router C.) Abort the ping operation D.) Exits privileged exec mode

1 Answers  

---

Which statement should you use to deny FTP access (only) from network 210 93 105 0 to network 223 8 151 0? A. access list 1 deny 210 93 105 0 0 0 0 0 any eq ftp access list 1 permit any B. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp C. access list 100 deny ip 223 8 151 0 0 0 0 255 any eq ftp access list 100 permit hp any any D. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp access list 100 permit ip any any

1 Answers  

---

What does the Spanning Tree Algorithm (STA) do? A.) Restore lost frames B.) Builds routing tables for routing through an internetwork C.) Forward packets through a switch D.) STA is implemented by STP to prevent loops

1 Answers  

---

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

What is the extended IPX access list range? A.) 901-1000 B.) 100-199 C.) 900-999 D.) 1000-1000

2 Answers  

---

What command will not display the status of to1? A.) show int to1 B.) show to1 C.) show interface to1 D.) show interface

1 Answers  

---

Identify the command to configure the router to boot from an IOS located on a TFTP server? A.) boot system tftp IOS.exe 172.16.5.1 B.) boot system tftp 172.16.5.1 IOS.exe C.) boot system flash tftp 172.16.5.1 D.) boot system IOS.exe 172.16.5.1

2 Answers   HCL,

---

What is difference between baseband and broadband transmission in ccna?

0 Answers  

---

What is the default bandwidth size of t1 routers?

0 Answers  

---