Interested to Buy Any Domain ? << Click Here >> for more details...
The Cisco Catalyst 5000 switch supports full duplex. How
would you
enable it on the second port of the card in slot 1?
A.) router(config-if)# duplex full
B.) router(config)# duplex full
C.) router(config-if)# set port duplex
D.) router(config)#port duplex = full
E.) router(config-if)# set port 1/2 full
- 1 Answers
- 4260 Views
- I also Faced
- E-Mail Answers
How many potions of ip?
Which protocol you manually enable route summarization?
Identify the 2 methods to modify the routers boot sequence? A.) Setup program B.) Boot system commands C.) RXBoot D.) Config-register
Identify the 3 kinds of routes IGRP advertises? A.) Interior B.) Dynamic C.) System D.) Exterior
What is point-to-point protocol in ccna?
Can you explain L2TP?
Based on the DR AND BDR discussion i want to put one question the question is what is the name of protocol which is responsible;e for DR and BDR selection
What is the mac address?
Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
Which command do you use to set the Secret password to 'roundwood'? A.) enable login roundwood B.) enable password roundwood C.) enable privilege roundwood D.) enable secret= roundwood E.) enable secret login roundwood F.) enable secret roundwood
What is the igp (interior gateway protocol)?
Which command would you type to show SAP and RIP updates you are receiving on an interface? A.) sh ipx servers B.) sh ipx traffic C.) sh ipx interface D.) sh ipx route
CCNA 
