What is default time of hello packets in ospf?

0 Answers  

---

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

---

Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.

1 Answers  

---

Tell me which cable called roll-over?

0 Answers  

---

Which two commands show your access lists? (Choose two) A. show filters B. show access-lists C. show ip access-lists D. show running-config

2 Answers  

---

What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16

1 Answers  

---

Which show command should you use to view Frame Relay Local Management Interface (LMI) Frame statistics? A. show lmi B. show ip route C. show interface D. show statistics E. show frame-relay lmi

1 Answers  

---

what is routing and routed protocol ?

7 Answers  

---

A network is vow congested currently all the devices are connected through a hub. Which would best decrease congestion on this network? A. add a second hub B. replace the hub with a router C. replace the hub with a switch D. replace the hub with a repeater

1 Answers  

---

why we use AS no. in IGRP and EIGRP?

2 Answers   HCL,

---

Value in which type of access list?

0 Answers  

---

If you are in IOS user mode, which command do you use to enter the privileged mode? A. Set B. Enable C. Configure D. Privileges

2 Answers  

---