The Cisco Catalyst 5000 switch supports full duplex. How would you enable it on the second port of the card in slot 1? A.) router(config-if)# duplex full B.) router(config)# duplex full C.) router(config-if)# set port duplex D.) router(config)#port duplex = full E.) router(config-if)# set port 1/2 full

1 Answers  

---

Explain the difference between rip and ripv2?

0 Answers  

---

Which of the following is an example of the Physical Layer? A.) SQL B.) IP C.) LLC D.) DDP E.) Ethernet

1 Answers  

---

Define topology?

0 Answers  

---

CSMA/CD stand for which of the following? A.) Carrier Sense, Multiple Access with Collision Detection B.) Collision Sense, Multiple Access with Collision Detection C.) Collision Sense, Multiple Access with Carrier Detection D.) Carrier Sense, MAC address with Collision Detection

1 Answers  

---

hi jitendra i am sunil here and i am an engineering student from delhi i have lots of interest in computer network.i was in serch of doing communication through MAC adressess.can u help me?

1 Answers  

---

Explain what is eigrp?

0 Answers  

---

what is subnet mask?

5 Answers   HCL,

---

At which layer of the OSI model does the ping command operate? A. session B. network C. transport D. maintenance

12 Answers   EF, IBM, jetking, Nexlinx, Rkd, TCS, Wipro,

---

Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  

---

what is AD Value?

5 Answers   Cisco, Infosys,

---

Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses

2 Answers  

---