What is passive topology in ccna?
No Answer is Posted For this Question
Be the First to Post Answer
Identify the command to configure DLCI 100 on an interface e0? A.) Router(config)# frame-relay local-dlci 100 B.) Router(config)# frame-relay local-dlci 100 int e0 C.) Router(config-if)# frame-relay local-dlci 100 D.) Router(config-if)# frame-relay local-dlci 100 int e0
how can we block remote desktop for some user from cisco router through aaccess-list
Identify the command to copy a configuration file from a TFTP server to a routers active configuration? A.) Router# copy running-config tftp B.) Router# copy tftp running-config C.) Router# copy tftp 172.16.0.1 running-config D.) Router(config)# copy tftp running-config
Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance
Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended
What would be the first command from global configuration mode to enable RIP on your router for interface E0, with an address of 181.86.4.4 and mask of 255.255.255.0 ? A.) router rip B.) network 181.89.4.0 255.255.255.0 C.) router rip int e0 D.) router rip 181.86.0.0 E.) router rip 181.86.4.0 F.) network 181.86.0.0
On which interface we always apply access-list?
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
What do you use the Aux port for? A.) Console B.) Terminal editing C.) Modem D.) Backup logging
Where is the point between the customers site and the phone carrier that responsibility changes? A.) CO B.) Demarc C.) DCE D.) DTE E.) CPE
Given the configuration example<HR> <B>interface ethernet0 ipx network 4a ipx access group 800 out interface ethernet1 ipx network 3d interface ethernet2 ipx network 5c access list 800 permit 3d 4a</B><HR> Which two actions result from implementing this configuration? (Choose two) A. IPX network 5c will not receive any traffic B. Traffic from network 3d for network 4a will be forwarded out e0 C. Traffic from network 4a for network 3d will be forwarded out e0 D. Traffic from network 3d destined for network 4a will be forwarded out e2 E. The access list is applied to an outgoing interface and filters outbound traffic
Which two solutions are used to reduce the chance of distance vector routing loops? (choose two) A. split horizon B. route poison C. area hierarchies D. link state algorithms