Which command will display the encapsulation type on interface serial 0? A.) show interface s0 B.) show all C.) show int s0 encap D.) show encap s0 E.) show encap

1 Answers   Cisco,

---

The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments

2 Answers  

---

What is meant arp and rarp?

0 Answers  

---

What is the juncture at which the CPE ends and the local loop portion of the service begins? A. Demarc B. CO C. Local loop D. Last-mile

1 Answers  

---

You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp

2 Answers  

---

How does rip differs from igrp?

0 Answers  

---

Which can be true regarding VLANs? A.) They are created by location B.) They are created by function C.) They are created by department D.) They are created by group

1 Answers  

---

What command will not display the status of to1? A.) show int to1 B.) show to1 C.) show interface to1 D.) show interface

1 Answers  

---

Can yo define LNS

0 Answers   CCIE,

---

Identify the switching method that receives the entire frame then dispatches it? A.) Cut-through B.) Receive and forward C.) Store and forward D.) Fast forward

2 Answers  

---

Cisco routers use wildcard masking to identify how to check or ignore corresponding IP address bits. What does setting a wildcard mask bit to 0 cause the router to do? A. It tells the router to check the corresponding bit value. B. It tells the router to ignore the corresponding bit value. C. It tells the router to check its alternate routing list. D. It tells the router to use its primary routing list.

2 Answers  

---

As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.

1 Answers  

---