What is the difference between ‘bit rate’ and ‘baud rate’?

0 Answers  

---

How signalling can be explained in D channel of ISDN?

1 Answers   Tulip,

---

What 2 commands verify end to end communications? A.) Trace B.) debug ip session C.) Ping D.) Route

2 Answers  

---

What is hold down time formula of ospf?

0 Answers  

---

Identify the type of hardware required to connect a Token ring network to an Ethernet network? A.) Repeater B.) TR-Enet C.) Router D.) Token Ring to Ethernet translation hub

1 Answers  

---

There are two processes to pair MAC address with IP addresses. Which process finds an IP address from a MAC address? A. RARP B. ARP C. RIP D. IGRP

3 Answers  

---

Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

3 Answers  

---

What is the Difference between Switch and Bridge?

9 Answers  

---

Can you explain CHAP?

1 Answers   CCIE,

---

What is the default encapsulation of Netware 3.12? A.) Ethernet_II B.) 802.5 C.) 802.2 D.) 802.3

1 Answers  

---

You want to enable both arpa and snap encapsulation on one router interface. How do you do this? A. The interface can handle multiple encapsulation types with no extra configuration. B. Assign two network numbers, one for each encapsulation type. C. Enable Novell-ether to run multiple encapsulation types. D. Both arpa and snap are enabled by default so you don't have to configure anything.

2 Answers  

---

Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc

1 Answers  

---