Which command will display the encapsulation type on interface serial 0? A.) show interface s0 B.) show all C.) show int s0 encap D.) show encap s0 E.) show encap

1 Answers   Cisco,

---

9. Which STP state prevents the use of looped paths? A. Blocking B. Listening C. Learning D. Forwarding

2 Answers  

---

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---

What is the terminal emulation, in which layer it comes?

0 Answers  

---

2. What are the valid ways to segment a LAN? (Choose all that apply) A. Repeater B. Bridge C. Switch D. Router

2 Answers  

---

Which Circuit is mostly used by Clients in Frame-Relay PVC or SVC ?

5 Answers   TATA,

---

Which defined peer ip address an local subnet belong to crete?

0 Answers  

---

Which of the following will apply IPX sap access list 1010 for incoming traffic, assume you are at the interface configuration? A.) ipx input-sap-filter 1010 in B.) ipx input-sap-filter 1010 C.) ipx access-group 1010 in D.) ipx access-list 1010 in

1 Answers  

---

Which of the following are logged when IP access list logging is enabled? A.) source address B.) protocol C.) source port D.) destination address E.) access list number F.) destination port

1 Answers  

---

Which configuration task must you complete if a remote Frame Relay router does NOT support Inverse APP? A.configure static maps B.define an IP address locally C.disable DHCP on the Frame Relay router D.configure a static route to the remote network

1 Answers  

---

Identify 3 characteristics of an IP address? A.) Contains a network portion and a host portion B.) 32 bits long C.) Unique to each network D.) Part of the default Cisco configuration E.) Referred to as the hardware address

1 Answers  

---

Why we are not using subnet mask of class A in class C?before answering this question, just think upon if we do this then we don't need to move to IPv6.

2 Answers  

---