Answer / sankar

take console by using #. after that you will get sc>
1.Sc>showenvironment= verify the output system has any
harware failer
if every thing good
2.sc>console... if dose not respoend
3.sc>poweroff
the system will completely poweredoff
Then power it on
4.sc>poweron
Then connect to console
sc>console
verify the system state
if system is not boot up it will in >ok promt
if system is up it promt for passwd

try connect to the server

Answer / venkat

take console by using #. after that you will get rsc>
rsc>console
system goes to ok prompt
ok>
In ok prompt give coomand
ok>printenv
check auto-boot?false or true.if it is true make it is
false.
If you want to change auto-boot?true,give command like
ok>setenv auto-boot?false
ok>reset-all
ok>boot
if it is still sytem is hang...
ok>setenv boot-device=mirrdisk rootdisk
ok>reset-all
ok>boot mirrdisk

How can you unencapsulate a boot disk in VxVM?

5 Answers  

---

Which is the H/W u r using?

1 Answers  

---

How do you give a user access to an application or program that needs to run as root without giving them the root password?

2 Answers   Infosys,

---

If you mistype a password, how do you clear it out to retype the password again?

11 Answers   Genpact, WNS,

---

How to see open ports?

2 Answers   IATA, Locuz,

---

where the NIS will be actually used (Situation)

1 Answers   IBM,

---

What is /etc/system for?

3 Answers  

---

How to findout particular file in the backup tape with the help of ufsdump

2 Answers   IBM,

---

I have a hard disk. After inserting this what are the recommended steps to install it on your solaris

1 Answers   HCL,

---

I want to Know how many LUNs are in my Solaris10 server as well as NIC cards ?

7 Answers   Verizon,

---

In a two node cluster i have typed #hastart command in one node.The cluster is starting in second node also,what is going in background?

0 Answers   Thomson Reuters,

---

Explain sar commands.?

3 Answers  

---