Answer / guest

Answer: D

Define the virtual channel?

0 Answers  

---

To which layer ICMP belongs

7 Answers   CMS,

---

What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace

2 Answers  

---

The Network layer works with which of the following: A.) Globules B.) Bits C.) Packets D.) Segments E.) Frames

3 Answers  

---

CO is an acronym for which of the following? A.) Central Office B.) Capital Office C.) Central Operator D.) Company Office

1 Answers  

---

what is the difference between eigrp and ospf

6 Answers   IBM, Wipro,

---

Identify 3 methods not used to prevent routing loops? A.) Holddown timers B.) Sequence numbers C.) Triggered updates D.) Split horizon E.) Area hierarchies F.) Order of router startup

3 Answers   IIHT,

---

You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.

1 Answers  

---

How ICMP is used in ping and traceroute facilities

3 Answers  

---

Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A. trace B. ping C. telnet D. bootp

1 Answers  

---

Which ISDN protocol prefix specifies switching and signaling? A.) I B.) E C.) Q D.) S

1 Answers  

---

In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physcial interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay

2 Answers  

---