The CSMA/CD Ethernet IEEE committee is defined as which of the
following?
A.) 802.2
B.) 802.3
C.) 802.4
D.) 802.5
Answers were Sorted based on User's Feedback
What is the difference between ‘bit rate’ and ‘baud rate’?
What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN
How do you configure a cisco router for routing ipx?
How to find Router Serial interface MAC address?
What is the default bandwidth size of t1 routers?
Eight stations connected to separate 10 Mobs pods on a Layer 2 switch will give each station how many Mobs of bandwidth? A. 1.25 B. 4 C. 16 D. 10 E. 80
What is a key use of a device hardware address? A. to obtain a vendor code / serial number from the user B. to transmit a frame from one Interface to another Interface C. to transmit a packet from one local device to another local device D. to transmit data from one local device to a remote device across the internet E. to contain logical information about the device to use for end-to-end transmission
Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, the router enters in its table the number 16 to signify destination unreachable
What is raid in ccna?
Identify 2 transport layer protocols? A.) IP B.) TCP C.) CDP D.) ARP E.) UDP
What is difference between fast ethernet and ethernet port?
13 Answers Bank of Baroda, Bank Of India,
Identify the purpose of the following command 'ip route 192.168.100.0 255.255.255.0 10.1.0.1' A.) Enabling a dynamic routing protocol B.) Creating a static route to the 10.1.0.0 network C.) Teaches the router about the distant network 192.168.100.0 and how it can be reached via 10.1.0.1 D.) Assigining the IP address 192.168.100.0 to an interface