Answer / guest

Answer: B

Answer / isaq

B

What are the difference between IPv4 & IPv6?? Can anyone explain more details about it..!!

9 Answers   HCL,

---

What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address

1 Answers  

---

whats the routing protocol supporting in both juniper , cisco routers.

10 Answers   HCL,

---

Which of the following is an example of the Physical Layer? A.) SQL B.) IP C.) LLC D.) DDP E.) Ethernet

2 Answers  

---

What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services

3 Answers  

---

hi friends i have some problem regarding technical round ahr round plz tell me what should the right answer technical questions 1 what is brouter 2 what is the menaing of 10 base2, 10 base 5 and 10baset 3 what is diffrence between bit rate and baud rate. and this question was tooooooooooo much difficult to me that hr said to me that rank me after the taking the all short of interview

5 Answers  

---

Which type of transmission bus topology support?

0 Answers  

---

Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0

1 Answers  

---

what is the difference between a passive and active hub?? which is better ??

12 Answers  

---

Suppose there are 3 pc's pc1 pc2 and pc3 all are connected with each other pc 1 is able to ping pc2 and pc3 but pc2 and pc 3 not able to ping pc 1 then what is an issue troubleshoot it?

0 Answers   Wipro,

---

CO is an acronym for which of the following? A.) Central Office B.) Capital Office C.) Central Operator D.) Company Office

1 Answers  

---

What is the role of the LLC sublayer?

0 Answers  

---