Answer / guest

Answer: D

Which protocol gets a hardware address from a known IP address? A.) RARP B.) TCP C.) IP D.) BootP E.) ARP F.) ICMP

3 Answers  

---

Your Ethernet interface currently has the IP address of 1.1.1.1/24. You would like it to have a second IP address of 2.2.2.2/24. Which command will do that? A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0 B.) ip address 2.2.2.2 255.255.255.0 secondary C.) ip address 2.2.2.2 255.255.255.0 D.) This cannot be done, you can only have 1 IP address per physical interface. E.) ip address 2.2.2.2 /24

1 Answers  

---

Explain some overview of EIGRP?

2 Answers  

---

What command displays the OSPF section of the running-configuration?

1 Answers  

---

What is the mesh network?

0 Answers  

---

Which OSI Reference Layer is concerned with path determination? A.) Datalink B.) Physical C.) Network D.) Transport E.) Session

2 Answers  

---

What is the maximum hop count for Link-State protocols? A.) 15 B.) there is no hop count limit C.) 256 D.) 16

1 Answers  

---

What is VLSM ?

5 Answers   HCL,

---

What does a router change in a packet when it forwards a packet to the next hop? * A: Destination physical address * B: Destination network address * C: Destination network address and the destination physical address

10 Answers   Microland,

---

As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.

1 Answers  

---

Which term describes the process in which frames from one network system are placed inside the frames of another network system? A. bridging B. tunnelling C. data link control D. generic routing E. packet switching

1 Answers  

---

Which of the following is a layer 2 device? A.) Switch B.) Bridge C.) Repeater D.) Hub

2 Answers  

---