Interested to Buy Any Domain ? << Click Here >> for more details...
1.hi all, my question is how maximum number of ports can
exist in a switch?
2.Which type of switching good in using and why?
- 4 Answers
- 8104 Views
- HCL, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / kashyap.puja.1988
ans:according to me 128 maximum port is exist.
ans:2 :fragmentfree switching is good in using.
| Is This Answer Correct ? | 9 Yes | 3 No |
Answer / anony
HI a Cisco switch will have a maximum of 48 ports in one
slot. Also it depends on the model of the switch. In
certain switches additional modules can be added(ex: 6500
series) whereas in certain it cannot be added (ex: 2960)
| Is This Answer Correct ? | 4 Yes | 1 No |
Answer / s.m.feroz ahmed
Hi,
Switch is a HardWare device which can support a minimum of
32 ports and maximum of 128 port switch .Switch is a
configuring device with a console port for
configuration .where one can configure switch in such a
manner that permit and deny access is possible by
configuring switch.
Cisco switch is good in using.
| Is This Answer Correct ? | 1 Yes | 2 No |
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physical interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
What must be true for two Routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D)Configured for PPP
LAN stands for which of the following? A.) Local Area Network B.) Local Arena Network C.) Local Area News D.) Logical Area Network
When would you use ISDN? A.) To connect LANs using POTS B.) To support applications requiring voice, data, and video C.) When you need a consistent and very high rate of data speed D.) To connect to IBM mainframes
in stead of 0.0.0.0 wild card mask what u can write after ip?
Which command we use for ping in ipv6?
Which service uses telephone control messages and signals between the transfer points along the way to the called destination? A. Signaling System 7 (SS7) B. Time-division Multiplexing (TDM) C. X.25 D. Frame relay
Explain why ip address called logical address?
Can anyone explain the STP Security features. Just like BPDU guard, Root Guard. Hi JITENDERA, i m specially looking for u?????
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message
Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces
Cisco's implementation of ISDN BRI has multi protocol support, SNMP MIB support, and what other features? A.) Call waiting B.) Compression C.) ADSL D.) 1.544 Mbps E.) Call screening F.) Negative 'G' support
CCNA 
