Answer / s.m.feroz ahmed

Hi,

To configure Cisco Router One should connect DCE Port to
Console port on CPU and Serial Ethernet (S0) to Ethernet
port on CPU with the help of straight cable one to Serial
Port on Router and other end to ethernet port on CPU.

Answer / jigar patel

hi,


To config router one should connect your router console
port to PC com port by roll over cable.
then one shud start hyper terminal to config router through
pc

What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  

---

What is the maximum hop count for IP RIP? A.) Infinity B.) 16 C.) 15 D.) 1

2 Answers  

---

what is the subnet for the host ip address 172.16.210.0/22

8 Answers   IBM, Microland,

---

Identify 3 IP applications? A.) AURP B.) ARP C.) Telnet D.) SMTP E.) DNS F.) RARP

2 Answers  

---

Name the command we give on privilege mode for coming back to user execution mode?

0 Answers  

---

What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services

1 Answers  

---

Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classful address, no subnets C.) Enable CDP so neighbors can be detected D.) Configure all networks in Area0

1 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

Does a bridge divides a network into smaller segments?

0 Answers  

---

Which protocol will let neighbor routers know if your internetwork experienced congestion on a serial port? A.) BootP B.) IP C.) ICMP D.) ARP E.) FTP F.) RARP

3 Answers  

---

What is Cisco's default encapsulation method on serial interfaces? A.) ANSI B.) Cisco C.) Q933a D.) HDLC

2 Answers  

---

Which peer authentication method and which ipsec mode is used to connect to the branch locations?

0 Answers  

---