What is the IP extended access list range?
A.) 1000-1099
B.) 100-199
C.) 1-99
D.) 101-200
Answers were Sorted based on User's Feedback
Answer / guest
Answer: B
100-199 is the range for Extended IP access lists.
Is This Answer Correct ? | 35 Yes | 0 No |
Answer / haja bahurudeen
Ans : B
Standard Access list :1 - 99
Extended Access list :100 - 199
Is This Answer Correct ? | 15 Yes | 1 No |
Tell me which protocol called rapid protocol?
Select the correct statements about PPP and SLIP for WAN communications? A. PPP uses its Network Control Programs (NCPs) component to encapsulate multiple protocols. B. PPP can only transport TCP/IP C. SLIP can only transport TCP/IP. D. SLIP uses its Network Control Programs (NCPs) component to encapsulate multiple protocols.
Tell me which multicast ip eigrp protocol use?
What is ‘round-trip time’?
When ospf protocol advertise its routing table?
Identify the keystroke to position the cursor to the beginning of a command line? A.) Ctrl-A B.) Ctrl-Ins C.) Ctrl-B D.) Ctrl-Z
srry for inconvnce ..here is complete qs...ignore the previous 1 3 router configured with RIP & Ripv2 rotuer 1- connected with router 2 having sr ip 10.0.1.2 routing : ripv2 E0:192.168.1.10 router 2: connected with router 1 and router 3 having sr 0 ip 10.0.1.3 & sr 1 ip 11.0.1.2 routing :rip & ripv2 E0=192.168.10.2 router 3: connected with router 2 having sr ip 11.0.1.3 routing: rip E0=172.16.10.2 is there communication possible?
Of the following, which reason applies to dividing a large network into two or more smaller networks? Performance Security Address Management All of the above
Which of the following is true? A. The default is to send debug output to the console screen. B. To view debug output from a telnet session, the "terminal monitor" command must be used C. If the "logging buffered" command is used, the debug output would be sent to RAM and can be viewed with the "show log" command D. If the "no console loggin" command were configured, output would besent to a telnet session E. All of the above F. None of the above G. A, B, and C. H. A, C, D, and E.
Identify the command to configure the router for IGRP autonomous system 100? A.) Router(config)# router igrp 100 B.) Router> router igrp 100 C.) Router# router igrp 100 D.) Router(config)# router igrp
What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.
Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM