Interested to Buy Any Domain ? << Click Here >> for more details...
Identify 3 characteristics of a MAC address?
A.) Burned into the NIC
B.) 48 bits long
C.) Length is 32 bits
D.) Used to deliver the frame to the end device
E.) Contains a network portion and a host portion
- 2 Answers
- 20343 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A B D
The MAC address is 48 bits long not 32. It does NOT contain
a network
and host portion with the address. It is used to deliver the
frame to
the destination device.
| Is This Answer Correct ? | 15 Yes | 7 No |
What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address
A company running RIP V1 protocol on their 2 seperate networks, each nw has 14 routers, if the two nw wants to be merged with each other total no of routers will be 28. but rip metric is hop count(15). What needs to be done if this setup needs to be work ?
What type of Ethernet operation allows only one entity to transmit at a time? For example, if someone else is transmitting, they must wait. A.) Full-Duplex B.) Dual-Duplex C.) Half-Duplex D.) Latex E.) Quarter-Duplex F.) Suplex
What is the difference between the user mode and the privileged mode?
Which of the following is a routing protocols? TCP RIP SMTP UDP
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI
Explain how many types of ends in wan?
Which two of the following are valid ways to have multiple encapsulation types on a single interface? A.) This is not possible B.) subinterfaces C.) additional physical interfaces D.) secondary addresses
Novell NetWare has an Ethernet frame type called Ethernet_802.2. What is the matching Cisco command line keyword for this encapsulation method? A.) gns B.) arpa C.) snap D.) sap E.) novell-ether F.) dix
Identify the command to display the IP routing table? A.) show route B.) show ip route C.) show ip table route D.) show ipx route
The Internet Control Message Protocol occurs at what layer of the seven layer model? A.) Physical B.) Transport C.) Session D.) Datalink E.) Presentation F.) Network
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message
CCNA 
