Interested to Buy Any Domain ? << Click Here >> for more details...
i am studying in bechanical engineering in M,S,University at Baroda.i and my friends want to take one month industrial trainning in mechanical engineering company.pleas send some company's name and procedure.
2008i am interested in refrigeration and air conditioning systems.please send me name of this type of company in baroda,gujarat.
1827CAN ANY ONE TELL ME WHEN WILL CONDUCT ASSISTANT MOTOR VEHICLE INSPECTOR /RTO APPLICATIONS WILL RELEASE
2050Post New Mechanical Engineering Questions
draw IRON-CARBON diagram.
what type of questions will be there in the written paper of tata motors ?
WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C
What for zinc finds applications ?
What is the use of divider?
define material grades 15b25,10b21,scm-415,16mncr5 in detailwith their compositions
What is the use of chuck?
What are the causes of dirty lubricating oil?
Explain the applications of ferrite material?
hai this is sreenu...i also applied for the post of PO in syndicate bank..
In Turbine how the balence piston works and what is the direction of leak of steam flow.
Define Fluidised bed boiler ?
How do you design a system which is required to experience a shock force of 15G in 10 milliseconds?
Which instrument has all the features of try-square, bevel protractor, rule and scriber?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
