Mechanical Engineering Interview Questions
Questions Answers Views Company eMail

how can we calculate boiler capacity?

4 28209

differance between head & total head in pump?

2 2821

function of gland in steam turbine ? what is requirement of de-superheat in steam turbine what is purpose of sprey line for gland?

1 3108

plese send me the rrb model questions for JE mechanical



please send me model question papers for DVC Examination diploma mechanical


Mention some of the major contributions made by you in your present and previous jobs:


tell about Automobile engineering

2 2293

Relatesd Applied Mechanics



why the tanker lowery have elliptical shape?

ITC Infotech,

2 2958

What is meant by water hammering in steam line?why it is happening and how to overcome the same?

4 3256



1 3826

how do you close arc into circle in catia



a 20ph motor runnig a load with direct belts, can we use 10hp motor for the same load with the help of gear where motor rpm 900 and load rpm 250

1 1702

type of bearing used in conveyor pulley

4 4247

What is the difference between a mechanical engineer & a Marine engneer?



Post New Mechanical Engineering Questions

Un-Answered Questions { Mechanical Engineering }

1) Any pipe line working fluid may water / steam on it one manual isolation valve suppose one side of valve 6 kg/ cm^2 pressure (i.e. up stream) and other side is “ 0” kg/ cm^2 pressure(i.e. down stream) . So how much Tourqe required for opening the valve in terms of Newton force wheather normal man can open this valve. (for reference pipe nominal bore is 100 NB )


Please mail me the Satyam Computers (Mechanical Division, Satyam Technologies, Hyderabad & Bangalore) question papers on Design & strength of materials. Will be very


What is the Self & starter? what does it do in the in Genset


Enumerate some trouble of fuel injection valve


Would you please provide me with questions collected for interview regard to pressure vessel, which is in the aspects of welding, NDT, materials and painting? Please send these questions&answers to within 1 week, Thank you for your help. Rgs!


what is cyclon seperator and water column?


What is the relationship between hardness and tensile strength?


Draw L.O. system in diesel engine?


how we have to face the interview?


in tpp how steam pr. decreases from steam drum to main steam line


What are the causes of damage of diesel engine exhaust Valve?


Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb


alignment formulae for any two shafts for shim correction


"In boiler, what does steam and smoke goes out to the funnel. What reason?"


hall ticket copy