What is kingpin offset? State some of its application.

742

difference bitween CPC & SQC

2154

High speed gear is obtained in the case of sliding mesh gear box when a) Motion is transferred through the clutch gear to lay shaft gear b) Main shaft is coupled to the clutch shaft c) Smallest gear on the lay shaft is engaged d) Largest gear on the lay shaft is engaged

885

Differentiate between stress and strain.

602

Explain the reason that why the tyres are always black in colour. Is this phenomena related to the heat conduction?

562

Define riveted joints.

710

What is the function of commutator in starting system?

545

Propeller shaft is used for the purpose of a) Transmitting the drive from the transmission to the bevel pinion of the final drive b) Transmitting the drive from the crankshaft to the road wheels c) Transmitting the drive from the transmission to the road wheels d) Transmitting the drive from the crankshaft to the bevel pinion of the final drive

837

Will engine performance be damaged by mixing oil in fuel of four stroke bike ?

610

How much diesel does 1000 kva rating dg set at full load consume?

608

i had applied for 6 categories for rrb section engineers posts 2 different rrb boards 2 those i was eligible of an single notificatoin. do i need 2 write different exams or single exam

2032

Explain various types of breaks.

599

What happens if you use petrol in diesel engine?

623

In a synchromesh device, when members G1 and F1 are slid to left and cones M1 and M2 are in contact, a) Direct gear is obtained b) Second gear is obtained c) Third gear is obtained d) Reverse gear is obtained

851

Explain the reason that why big tyres are used in rear of vehicles

739