what is the meaning of the capital ique4 9685
how to calculate the p/v ratio, break even point and the margin of safety ratio when following statements are given. sales(1,00,000 units @ Rs.10/-) 10,00,000 Variable costs 5,00,000 contribution 5,00,000 Fixed costs 3,00,000 Net Profit 2,00,0004 32122
distinguish between Bill of Exchange and Promissory Note
How we can create SAS USER DEFINED CODE?
how much allowable resistance that can be difference in motor all coils?
Mention what is the difference between Swift and ‘Objective-C’ language?
"In boiler, what does steam and smoke goes out to the funnel. What reason?"
When a sales order contains normal(norm) and third party items(bans) how does the material reacts? Next order comes as make to order(0001), another is BOM. So every time we have to change the item category group in mm02 OR is there a process to expand the same material with norm, bans, 0001, erla?
Tell me about a difficult obstacle you had to overcome recently at work? How did you overcome this?
If mft not act when spark failure 3 time what problem will happen in boiler side
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
what is groups and and ledgers in tally can you give why we need to prepare them
how to we pass a purchase entry in item invoice mode where some advance has been paid to the party. the purchase entry should get offset with the advance payment entry so that it does not appear in the bill outstanding or bills due list. please guide.thank you
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
How to configure for slow connectionsinvocations
Hi Friends, I wish to start my career in manual Testing as I believe I am ready to face Interviews.I have good domain knowledge in banking(investment and retail) and insurance.To be in the competition I have added three years of testing experience to my CV apart from my domain experience. Can someone please advice some real time tips which can help in facing the interview. Thanks in advance
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number