hello,am milan mohite,i have completed B.PHARM,in 2008.and now do M.B.A from ignou,and D.P.P.M,from IPER{PUNE},please suggest me best coaching institute in pune for drug inspector,and send me model question paper for prepration of D.I. on my e.mail id - milan_mohite@yahoo.in Thanks.
What are the key assumptions underlying your projections? - Venture Capitalists
What is Planning horizon and how does it impact MRP and MPS run results ?
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
What is the web download scheduler?
what is performance test.need defination
can any body sand me previous exampapers of jr. engineer (mechanical)
In interviews interviewers asked me "what is your responsibility in your project?". what is the answer for this question. Pls tell me the answer anybody. Thanks in advance.
how to configure cisco router & switches plz provide me path steps?
In the house keeping section of an MVS assembly language program, like the one below STM R14,R12,12(R13) BASR R12,R0 USING *,R12,R11 LA R11,2048 LA R11,2048(R11,R12) .... .... 1. What if BASR R12,R0 IS NOT PRECEDE USING *,R12,R11? 2. USING (base address), REGISTER does USING directive says assembler to treat particular Register as a base register with the mentioned base address..in the above case * i.e current location counter..well if that is the case why we need BASR R12,R0 ? 3. What if I write like STM R14,R12,12(R13) BASR R12,R0 LA R11,2048 LA R11,2048(R11,R12) USING *,R12,R11 there is no address resolution being calculated in both LA statements so is it a right way to set Base register?..will there be any issues with Domain regarding R11 and R12?
why we use sodium salicylate in uv light calibration at TLC chamber
NPN transistor, SCR, Zener diode, LED, Varactor diode, Vortex meter, RTD, Resistor, Crystal
How would you attach pictures in Treeview Control?
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
write a code for this:trailer recordId contains a value other than 99, then the file must error with the reason ‘Invalid RECORD_ID’(User Defined Exception).
