why the ph scale range is 1 t0 14 and why not beyond 14 and not to below 1?
Answer Posted / ankit
water dissociates in 7H,7OH so it would be max14 and 7 is neutral
Is This Answer Correct ? | 2 Yes | 9 No |
Post New Answer View All Answers
For standardization of volumetric solutions, acceptance limit for concentration is considered as 10% of nominal concentration and %RSD as NMT 0.2% (for appropriate no. of replicates). But , if %RSD has not met, what should be further action?
How to fix the sample conc. in Related substances test by HPLC?
How they found 1mL of K.F reagent is equivalent to 5mg of water and if we change the composition of K.F reagent, is it can neutralize more amount of water?
If change in specification which parameter require to do for validation? if change in chromtographic condition then which parameter? if api change then which parameter? if change composition then which parameter? if old method not work out then whicj parameter? if additional one impurity added then which parameter of validation require to do on above each conditions? elaborate separately
How to know the estimated LOQ concentration in ppm
If vendor having more imp than monograph then how to proceed? and how to set spec?
how require to set assay concentration for standard and sample?
Why perchloric acid used for potentiometric titration
how require to interprit the method precision data of hptlc?
How much is the standard area for glc analysis
what is third integration
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
Ph meter can show more than 14 ph reading? Why ph range in between 1 to 14 only?
What is the diffrence in japan mkt requirement in analytical method validation over US?
if your impurity coeluting with each other in that situation how require to set specification? is it acceptable?