Answer Posted / nisha
we show negative peak because of impurites
Is This Answer Correct ? | 1 Yes | 11 No |
Post New Answer View All Answers
In the isomers,enantiomers give the only physical properties present such that no chemical properties present.
how to calibrate hplc & gc
A ha tc is actual defination of retention time?
can i use hplc detector to uplc and why?
Hi sir if any product monograph not given known impurities (may be 5 impurities) specifications then how we require to proceed for inhouse formulation?
why does used dry caffien in HPLC calibration?
How to compare XRD graphs against standard and carry polymorpism study of API's by powder XRD method?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
how to select short coloum and long coloumn for new molecule
why we are using benzene, anyline in acetic anhdride assay titration method?
If change in specification which parameter require to do for validation? if change in chromtographic condition then which parameter? if api change then which parameter? if change composition then which parameter? if old method not work out then whicj parameter? if additional one impurity added then which parameter of validation require to do on above each conditions? elaborate separately
How do we get end points and how many end points are possible for citric acid and di-acid not theorotically answer should be given practically.
Why only Copper standard is used to calibrate Atomic Absorption spectrophotometer?
please explain about aluminium hydroxide assay
if tech transfer fails whay require to do?