why we are using in ph calibrations ph4,7,9.2 buuffers only?
- 3 Answers
- 16419 Views
- Reddy Labs, Unichem, I also Faced
- E-Mail Answers
Answer Posted / amar
pH range is 0-14 where as 7 is the neutral. So, In Acidic range below 7 and Basic range above 7 range we can do the calibration. For Acidic condition 0-7, 4 is the moderate pH. Where as in Basic Condition 7-14, 9.2 is the moderate pH. So, for these conditions we are performing 4,7 and 9.2 buffers for calibration. For pH Calibration we can extend calibration 1.65,4.01,7.00,9.25 and 12.45 for getting more accuracy in pH.
| Is This Answer Correct ? | 15 Yes | 3 No |
Post New Answer View All Answers
What is delay volume?
how require to set assay concentration for standard and sample?
CAN WE DETERMINE THE PEAK PURITY IN GAS CHROMATOGRAPHY ANALYSIS?
how much mass should be there in volumetric flask while in preparation of sample for assay?
what are the standard methods for HPLC?
How do we fix the sample concentaryion in hplc method development. What is the basis?
How they found 1mL of K.F reagent is equivalent to 5mg of water and if we change the composition of K.F reagent, is it can neutralize more amount of water?
what is definition of validation? which components are followed give detail?
How to set analyticl specification for combination products?
What is the difference between spectro meter and spectro photo meter?
What is control room temperature and which guide line says?
WHAT IS THE PURPOSE WE USE HCL, CHOPPER, BURNER, MONOCHROMATOR in AAS? PLEASE EXPLAIN BRIEFLY
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
how you fix the limits of impurities?
How doing qbd practically?
