A new drug substance found fail to meet specification for
an unknown Impurity during stability study(Specific
change),how would further proceed?
- 2 Answers
- 6419 Views
- I also Faced
- E-Mail Answers
Answer Posted / vikas kumar
Firstly it was not clear on which condition we are getting
the OOS and at which time point.
It it was failed in Accelerated condition than we have to
look definately for intermediate condition for 12M.
if it was in long term condition than we have to firstly
raise the OOS and and proceed as per OOS procedure similary
we can check wether the method was stability indicating or
not.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Please tell me about the pH of Polycaboxylic ether is it in the 5-6 range ever or more than 6
What is the main difference between ODS1 and ODS2 Hplc column.
How require to perform linearity as per ANVISA? What are the acceptance criteria?
what you do when compound having dwel wavelength?
how to decide for one product require water content or LOD?
If change in specification which parameter require to do for validation? if change in chromtographic condition then which parameter? if api change then which parameter? if change composition then which parameter? if old method not work out then whicj parameter? if additional one impurity added then which parameter of validation require to do on above each conditions? elaborate separately
how can I make the copper get white bye any salt or acit?
inhouse product is in capsule form in combination and RLD is in tablet form then can we proceed for multimedia CDP? in inhouse capsule product disso is paddle with sinker in release media is there then RLD product in tablet form then with same as paddle with sinker we can proceed n.a.?
We use hicrome 10 cxs column in hplc analysis....pls tell me.. what is the meaning of 10 cxs?
Please give idea about method development for cleaning method and how maco level establish
how you start RS method development when for new product?
Many times I don't got a caffeine peak in calibration of hplc using guard column ❓
Why a1% value is used for some product ? What is the criteria for selection a1% value ?
I have compare C2H2-air and C2H2-N2O flame AAS on determination calcium. Both use same range of std to plot calibration curve. (2-6ppm) When i measure the sample with phosphate, KCl and LaCl, C2H2-N2O flame give false positive result, around 0.5ppm. When i measure the sample with phosphste, KCl and EDTA. C2H2-N2O flame also give 0.5ppm false positive. But both above mentioned sample would not give false positive when measured by C2H2-air flame. What is the reason?
why require to do water content for drug product?
