How did you conclude that when stressing a compond, all
degradation products have eluted in chromatogram?
- 7 Answers
- 10022 Views
- Matrix, I also Faced
- E-Mail Answers
Answer Posted / s.elumalai
The main aim of degradation study is to separate know
impurities in the case when we do not have know impurities
or to generate impurities from the sample by degradation.
Obviously one should know the process related impurities or
the degradation pathways. From peak purity by PDA or Mass
analysis one can conclude the purity of each peak eluting,
beyond that mass balance also account for peaks.If mass is
not balanced then one can conclude that some of the compound
are not eluted or may not have UV absorption.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Why potassium dichromate is used in calibration of uv?
How to compare XRD graphs against standard and carry polymorpism study of API's by powder XRD method?
Describe your field experience sample type collected,sample techniques,field measurements taken and equipment used?
What is stray light in uv what are units for stray light
IS THERE ANY EQUIPMENT TO CHECK AND CALCULATE THE POLARITY OF A LIQUID?
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
What is the difference between spectro meter and spectro photo meter?
on saturation solubility study data how we can find out the bcs class of drug?
Why only 1.2 million lux hours require in photostability study?
if peak get problamatic then what require to do?
how require to set assay concentration for standard and sample?
how to get accurate result for Residue on evaporation in purified water
why we use a particular hplc column for a particular compound give reasons?please
How we choose the mobile phase for method development.?
in dissolution if one bowl got 70 percent 2nd bowl got 80 percent and 3rd bowl got 90 percent then how proceed?
