what is the defination of calibration & verification?
- 9 Answers
- 27194 Views
- Divis Laboratories, I also Faced
- E-Mail Answers
Answer Posted / basha
calibraion is the checking the instrument with reference
standards they are in limit or out of limit
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
if tech transfer fails whay require to do?
If we have 5 strength which is not dose proportinate and excipients also diffrent in each strength then how we can proceed for Force degradation? and excipient are same but not dose propotinate the how FD?
how to qualify the impurity?
A ha tc is actual defination of retention time?
if you given one product then which tests you will perform?
What is the accrptance criteria in RSD for RS method precision on basis of impurity percentages?
Which products will produce when acetic anhydride reacts with Ter-butanol, Sec-butanol, Iso butanol, Dimethylamine etc.
AT WHAT CONDITIONS WILL YOU ANALYSE A SAMPLE,WHICH ARE PRESERVED AT OTHER THAN THE AMBIENT CONDITIONS?(ie COLD STORAGE SAMPLES BELOW 20* CENTIGRADE?
What is Band broading effect explain
Why we used in n-butyl acetate water content terminology while in ethyl acetate we used moisture content terminology?
why require to do water content for drug product?
what is %labelled amount in content uniformity of dosage unit and its calculation?
What is column in chromatography?
What are usp limits for theoritical plats,resoution,tailing factor,peak to valley ratio
My question about gas chromatography sulfur chemiluminsecence detector. I test unknown sample gas by GC-SCD (calibrated ) and the result of *H2S is 279 PPM , *but when I test the same sample with the GC-TCD (calibrated ) the value of *H2S is 2500 PPM . I'd like to inform you that both GCs are calibrated and have very good operation conditions with stable parameters . the question is if the sample gas with higher H2S over detection limits of SCD detector (1000 ppm). why the result it 279 ppm Best regards
