Interested to Buy Any Domain ? << Click Here >> for more details...
If a router uses dynamic routing, how does it learn the
route to remote networks?
The router uses a DHCP request to obtain remote network
numbers.
The router uses a routing protocol to exchange routing
info. with other routers.
The router uses DNS request packets to obtain remote
network numbers.
The Network Administrator manually configures the remote
networks.
- 1 Answers
- 5060 Views
- I also Faced
- E-Mail Answers
Answer / jitendera kumar sinha
The router uses a routing protocol to exchange routing
info. with other routers
| Is This Answer Correct ? | 4 Yes | 0 No |
In IPSec what is SAD, SPD and SA's?
Where would network testing be included in an IP packet? A. IP Options field B. Identification field C. Type of Service field D. Reservation field
A router on one side of a PPP link uses the resonance RTR1 and the password COPP1-PWD. Which configuration line on RTR1 enables a connection between RTR1 and another router named RTR2? A. username, RTR2 password COPR1-PWD, B. username, RTR1 password COPR1-PWD, C. username, RTR2 password COPR2-PWD, D. username, RTR1 password COPR2-PWD,
What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable
In regards to TCP/IP, which class of address allows for the fewest valid Internet hosts? A.) D B.) E C.) Classes are not used in TCP/IP. D.) B E.) C F.) A
You have typed "ping" 172.16.101.1 and get the following display: Type escape sequence to abort. Sending 5, 100-byte ICMP Echoes to 172.16.101.1, timeout is 2 seconds: .!!!! What does the "." signify? A. That one message timed out. B. That all messages were successful. C. That one message was successful. D. That one message completed in under the allotted timeframe.
I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?
Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecting to non-Cisco equipment C.) You must use Q.933a encapsulation if connecting to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment
Differentiate full-duplex from half-duplex.
When does network congestion occurs?
What is a protocol
What does aaa stands for?
CCNA 
