When does network congestion occurs?
No Answer is Posted For this Question
Be the First to Post Answer
What are 10base2, 10base5 and 10baset ethernet lans?
What is the routing metric used by RIP? A.) Route poisoning B.) Split horizon C.) Hop Count D.) TTL
What are the advantages of a layered model in the networking industry?
Identify the correct IGRP configuration? A.) Router# router igrp 100 Router# network 10.0.0.0 B.) Router(config)# router igrp 100 Router(config-router)# network 10.0.0.0 C.) Router(config)# router igrp Router(config-router)# network 10.0.0.0
if 10 pc's connected from internet, in 8 pc's internet is correctly run but in other 2 pc's they can not access internet,what's the problem?
Your network is having IP problems connecting to one or more Frame Relay peer routers. Which two commmands should you use to show the routers that are reachable? (Choose two) A. show ip map B. show ip router C. show frame-relay map D. debug frame-relay map
What is the protocol number for TCP? A.) 80 B.) 21 C.) 11 D.) 6
Which ipsec rule is used for the olympia branch and what does it define? (Choose two)
here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.
Which OSI layer supports the communication component of an application? A.) Data-Link B.) Physical C.) Session D.) Presentation E.) Application F.) Transport
What is HDLC?
Identify 3 characteristics of IP RIP? A.) Distance vector B.) Administrative distance is 120 C.) Periodic updates every 60 seconds D.) Uses a composite metric E.) Can load balance