Dear Mr. JITENDERA KUAMR SINHA how are and how is your
family? Anyway can u send me your personal email address?
Answers were Sorted based on User's Feedback
Answer / jitendera sinha
to which address (e.mail) i have to send my personal email id
ok i am fine and i am working in bangalore as network engineer.
my email id is
jitenderasinha.it@gmail.com
Is This Answer Correct ? | 1 Yes | 0 No |
Answer / balachandar
IS THIS CCNA NETWORK INTERVIEW QUESTIONS?
BLA BLA BLA BLABLA..............
Is This Answer Correct ? | 0 Yes | 0 No |
What is the regional Telco office called, where the customers local loop terminates? A.) Demarc B.) DTE C.) DCE D.) CO E.) CPE
Can you explain transport and tunnel mode in detail with datagram packets?
Which OSI layer performs code conversion, code formatting and encryption? A.) Physical B.) Data-Link C.) Application D.) Transport E.) Presentation F.) Network
At what layer of the OSI reference model does FRAME-RELAY map to? A.) Session B.) Physical C.) Network D.) Presentation E.) Transport F.) Datalink
what are the different asymmetric algorithms?
What port does rip use?
The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments
Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured
Routers can learn about destinations through static routes, default, or dynamic routing. By default, a router will use information derived from __________. A. IGRP B. RIP C. IP D. TCP
When you mistakenly type the wrong command at the Router# prompt the router does a DNS lookup which takes about 20 seconds. Which command can you enter to prevent the router doing this in future?
Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#
Referring to the commands shown, what command must next be used on the branch router prior to traffic being sent to the router?