'Show cdp neighbors detail' show the following 3 pieces of
information?
A.) Hardware platform
B.) Software version
C.) Same as 'show version' command
D.) Up to 1 address for each protocol
E.) Non-direct connected routers
Answers were Sorted based on User's Feedback
The maximum distance on a 10BaseT network from the hub to a workstation is which of the following? A.) 500 meters B.) 1000 meters C.) 100 meters D.) 1500 meters
Identify the command that configures serial0 for PPP encapsulation? A.) Router(config)# encapsulation ppp B.) Router(config-if)# encapsulation serial ppp C.) Router(config-if)# encapsulation ppp D.) Router# encapsulation ppp
Which two physical interfaces support PPP? (Choose two) A. Ethernet B. Token Ring C. Synchronous serial D. Asynchronous serial
what is a malicious router?when it occurs? what is a malicious pacekt ?when it occurs?
If a router uses dynamic routing, how does it learn the route to remote networks? The router uses a DHCP request to obtain remote network numbers. The router uses a routing protocol to exchange routing info. with other routers. The router uses DNS request packets to obtain remote network numbers. The Network Administrator manually configures the remote networks.
Hi Jitendera, I continuously read your answers which is more knowlegable than books... Q.I am facing some problems in subnetting.can you plzz explain the subnetting process.. will be remain thankful
Extended IP access-lists (100-199) can be used to control traffic. Which command listed below will permit smtp mail to only host 3.4.5.6 ? A.) It is not possible for SMTP traffic B.) access-list 102 permit tcp any host 3.4.5.6 eq smtp C.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 23 D.) access-list 102 permit tcp any any eq smtp E.) access-list 101 permit tcp any 3.4.5.6 0.0.0.0 eq 25
How would you set the clock rate to 64K, on interface serial 0, from the interface configuration mode? A.) clock rate 64000 B.) bandwidth 64 C.) clock 64 D.) rate 64 E.) clock rate 64k F.) clock rate 64
What is point-to-point protocol in ccna?
Given the following output, how can we close Telnet session 2? (Choose two) CCNA2620#show sessions Conn Host Address Idle Conn Name 1 131.108.100.152 131.108.100.152 0 131.108.100.152 *2 126.102.57.63 126.102.57.63 0 126.102.57.63 ❍ A. Press the Enter key and enter exit. ❍ B. Enter disconnect 2. ❍ C. Press the Enter key and enter disconnect 2. ❍ D. Enter close 2.
which utility should use to test whether TCP/IP has been initialized on a system.friends plz post the answer with explaination..
4. What is a disadvantage to using bridges in your network? A. Filters by MAC address B. Stops broadcast storms C. Doesn't stop broadcast storms D. Can only use up to 4 bridges in any LAN