Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between a passive and active hub??
which is better ??
- 12 Answers
- 55648 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / adeel
Active Hub is Centeral connecting device in a network
=>It Genrts the signals
=> Active Hubs are Little smarter than the Passive Hubs
=> Active Hub strengthing the weak signals as it enters and exits the Hub
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / kamran
Passive hub do not amplify the electrical signal of incoming
packets before broadcasting them out to the network. Active
hubs, on the other hand do perform this amplification as
does different type of dedicated network device called
repeater.
| Is This Answer Correct ? | 1 Yes | 1 No |
as i m cccna holder ... then why i m going for bpo's ?
Identify the 3 characteristics of IGRP? A.) Uses hop count as a metric B.) Supports multiple unequal paths C.) Administrative distance is 100 D.) Configured with an Autonomous system number E.) Link state
Which port are used by Viruses? TCP or UDP?
What is the icmp protocol?
What is hold down time formula of ospf?
What do the following statements in an extended access list accomplish? access-list 101 deny TCP 172.16.4.0 0.0.0.255 172.16.3.0 0.0.0.255 eq 21 access-list 101 deny TCP 172.16.4.0 0.0.0.255 172.16.3.0 0.0.0.255 eq 20 access-list 101 permit TCP 172.16.4.0 0.0.0.255 0.0.0.0 255.255.255.255 A. This will block ftp traffic. B. This will block http traffic. C. This will permit ftp traffic. D. This will permit tftp traffic.
Identify the type of hardware required to connect a Token ring network to an Ethernet network? A.) Repeater B.) TR-Enet C.) Router D.) Token Ring to Ethernet translation hub
Mention the conversion steps of data encapsulation?
Explain the difference between collision domain and broadcast domain.
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch
What is the difference between OSPF Exteral Type 1 (O E1) & External Type 2 (O E2) routes????
Which layer is responsible for identifying and establishing the availability of the intended communication partner? A.) Application B.) Presentation C.) Transport D.) Session E.) Network
CCNA 
