Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0

1 Answers  

---

How do you set the encapsulation type to PPP for an interface? A.) encap ppp B.) ppp encapsulation C.) encapsulation ppp D.) encapsulation ppp enable E.) ppp enable encapsulation

2 Answers  

---

How does RIP differ from IGRP?

0 Answers  

---

Identify the hardware component used to store buffers, tables, running-configuration etc? A.) NVRAM B.) ROM C.) RAM D.) Flash

1 Answers  

---

HOW MPLS IS DIFFERENT FROM OSPF? WHY NOW A DAYS MPLS IS PREFERED OVER ANY NETWORK PROTOCOL?

1 Answers   Bank Of India, TCS,

---

---

how can we block remote desktop for some user from cisco router through aaccess-list

5 Answers  

---

Name the command we use for ping in ipv6?

0 Answers  

---

Based upon the 1st octet rule identify the range for a Class A address? A.) 1 - 126 B.) 192 - 223 C.) 128 - 191 D.) 1 - 191

4 Answers  

---

What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds

3 Answers  

---

How IEEE Calculate the Cost of Link (ex.. 10mbps is having Cost 100) Is there any formula or any test to calculate it.

2 Answers   IBM,

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

1 Answers   Cisco, HCL,

---

You need to come up with a TCP/IP addressing scheme for your company. How many network IDs must you allow for when you define the subnet mask for the network? A.) One for each WAN link B.) One for each router interface C.) One for each NIC installed in each client D.) One for each subnet with hosts E.) One for each host ID

1 Answers  

---