what is the concept of HA and FA in VPN tunneling?

0 Answers   CCIE,

---

What is the first step in data encapsulation? A.) User information is converted into data. B.) Frames are put into bits. C.) Data is converted into segments. D.) Segments are converted into datagrams and packets. E.) Packets are put into logical frame.

1 Answers  

---

Identify the command to configure a description on an interface? A.) Router> description Finance department B.) Router(config)# description Finance department C.) Router(config-if)# description Finance department D.) Router# description Finance department

1 Answers  

---

What are the IGRP stability features?

1 Answers  

---

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---

Which of the following are examples of the Transport Layer? A.) SQL B.) UDP C.) IP D.) LLC E.) ARP

1 Answers  

---

Identify the mode reflected by the following prompt 'Router'? A.) Setup B.) RXBoot C.) Boot mode D.) Privileged exec mode

2 Answers   Cisco,

---

completly describe th steps fo osi model when you enter http:/youtube.com

1 Answers   HCL,

---

what is the boot seqance of cisco router

5 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

what is frame realay.is it a circit switching technolgy if no then what technolgy it used

2 Answers   Volvo,

---

Which of the following is a connectionless protocol at the Transport layer? A.) UDP B.) ARP C.) ICMP D.) RARP E.) IP F.) FTP

2 Answers  

---