Explain the major types of networks and explain?
No Answer is Posted For this Question
Be the First to Post Answer
what is standard and extended acess list? what are the commands for extended and acess list?
Which way of communication bus topology use?
Identify the command to determine if an IP access-list is grouped on interface e0? A.) Router(config)# show ip interface e0 B.) Router> show ip interface e0 C.) Router# show interface e0 D.) Router# show ip interface e0
In transport layer, for connection oriented communication Three way handshake process is there to establish a connection. So question is that, when a host send an ACK messages to another host with host intend to establish a connection, the source host send it as Broadcast or unicast message? Cud anyone explain this. Thanks in advance.
A routing table contains static, RIP, and EIGRP routes for the same destination network. Which route would normally be used to forward data?
What are the two types of access lists that can be configured on a Cisco router? A. Standard B. Extended C. Filtering D. Packet
During encapsulation, in which order is information packaged? A. Data, Packet, Segment, Frame B. Segment, Data, Packet, Frame C. Data, Segment, Packet, Frame D. Packet, Data, Segment, Frame E. Frame, Data, Segment, Packet F. Bread, Peanut Butter, Jelly, Bread
Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active
Your Ethernet interface currently has the IP address of 1.1.1.1/24. You would like it to have a second IP address of 2.2.2.2/24. Which command will do that? A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0 B.) ip address 2.2.2.2 255.255.255.0 secondary C.) ip address 2.2.2.2 255.255.255.0 D.) This cannot be done, you can only have 1 IP address per physical interface. E.) ip address 2.2.2.2 /24
what is unike ip address
What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN
Explain the difference between routable and non- routable protocols?