What are the two types of access lists that can be
configured on a
Cisco router?
A. Standard
B. Extended
C. Filtering
D. Packet
Answers were Sorted based on User's Feedback
Answer / guest
Answer:: A & B
The access lists are standard and extended. Standard access
lists for IP
check the source address of packets that could be routed.
Extended
access lists can check the source and destination packet
plus check for
specific protocols, port numbers, etc.
Is This Answer Correct ? | 7 Yes | 0 No |
Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
In Cisco IOS software which command displays the backup configuration? A. show flahh B. show version C. show tftp-config D. show backup-config E. show startup-config
What is the size of IP address?
Which two solutions are used to reduce the chance of distance vector routing loops? (choose two) A. split horizon B. route poison C. area hierarchies D. link state algorithms
Identify the command to view the configuration-register value? A.) show register B.) display config-register C.) show config D.) show version
Which layer is responsible for negotiating data transfer syntax? A.) Network B.) Session C.) Application D.) Transport E.) Presentation
Identify the following components of the IPX address 2e.0000.0065.ed43 A.) Not a valid IPX address B.) Network = 2e, Subnet = 0000, Node = 0065.ed43 C.) Network = 2e.0000, Node = 0065.ed43 D.) Network = 2e, Node = 0000.0065.ed43
Identify the default serial encapsulation? A.) ISDN B.) HDLC C.) SDLC D.) Frame Relay E.) PPP
What port does rip use?
In stp which protocol is used for detrming root port root bridge ,forwarding port and blocking port
What are the two most common request/reply pair with ICMP messages when using the ping command? (Choose two) A. echo reply B. echo request C. source quench D. fragment onset E. information redirect F. destination reachable G. echo control message
Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay