Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  

---

Given the global configuration commands: 'banner motd #' 'Hello #' When would the message be displayed? A.) The message of the day banner shows up before login. B.) The message of the day banner shows up during logoff. C.) These commands are not the right syntax for MOTD. D.) Message of the day banners are displayed upon entering global config mode. E.) Message of the day banners are not possible. F.) The message of the day would be, 'Hello #'

1 Answers  

---

How can we configure Inter-VLAN in Layer 3 Switch? Remember one thing without Router.

7 Answers   Grace, HCL,

---

What is the Network Layer of the OSI responsible for? A.) Bridging B.) Routing packets through an internetwork C.) Regenerating the digital signal D.) Gateway services

3 Answers  

---

Which defined peer ip address an local subnet belong to crete?

0 Answers  

---

What is the draw back of eigrp protocol?

0 Answers  

---

How signalling can be explained in D channel of ISDN?

1 Answers   Tulip,

---

Identify the 2 commands the saves the running-config to NVRAM? A.) write memory B.) copy running-config startup-config C.) write network D.) write backup

2 Answers  

---

WHY DO WE USE the command interface Vlan 1 ip adress x.x.x.x sub mask what does it do .. what does it create.. i know when we create it we can remotely telnet inti a router=switch. but what is the diff bwt vlan and intface vlan. ... vlan 1 bieng a native vlan remains there eve if i dont gv switch an ip address .. lease suggest.

1 Answers   Wipro,

---

What is the function of Layer 2 Switch?

4 Answers   Amazon,

---

Which three statements about Frame Relay configurations using subinterfaces is true? (Choose three) A. Each subinterface is conferred either multipoint or point to point B. Any network address must be removed from the physical interface C. The configuration of subinterfaces is done in router (config-if)# mode D. Frame Relay encapsulation must be conferred on each subinterface

2 Answers   Wipro,

---

Identify the command to copy a configuration file from a TFTP server to a routers active configuration? A.) Router# copy running-config tftp B.) Router# copy tftp running-config C.) Router# copy tftp 172.16.0.1 running-config D.) Router(config)# copy tftp running-config

1 Answers  

---