what is difference between hub and router.....

5 Answers   Thomson,

---

What protocols can you use while testing Trace? A.) DECnet B.) CLNS C.) IP D.) Old Vines E.) Vines F.) Chaos

1 Answers  

---

When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop

1 Answers  

---

You are given the following address: 153.50.6.27/25. Determine the subnet mask, address class, subnet address, and broadcast address. A. 255.255.255.128, B,153.50.6.0, 153.50.6.127 B. 255.255.255.128, C,153.50.6.0, 153.50.6.127 C. 255.255.255.128, C,153.50.6.127, 153.50.6.0 D. 255.255.255.224, C,153.50.6.0, 153.50.6.127

2 Answers  

---

Which three are typical operational phases in a basic connection oriented network service? A. call setup B. data transfer C. load balancing D. call termination E. caller ID F. call prionflication G. data segmentation H. data and momma I. data link identification J. callering book

1 Answers  

---

---

What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network

1 Answers  

---

Switching methods include cut-through, store and forward, and a modified version of the first two methods. Which statement about switching methods is true? A. The store and forward method has low latency B. The cut through method of switching has high latency C. The modified version holds the packet in memory until 50 percent of the packet reaches the switch D. The modified version holds the packet in memory until the data spoon of the packet reaches the switch

3 Answers  

---

Which command displays the IPX SAP table? A.) show ipx sap B.) show sap C.) show ipx interface D.) show ipx servers E.) show ipx

1 Answers  

---

What does the IPX maximum path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---

Which layer of the 7 layer model provides services to the Application layer over the Session layer connection? A.) Transport B.) Application C.) Session D.) Network E.) Datalink F.) Presentation

2 Answers   CTS,

---

Which OSI layer handles physical address, network topology? A.) Presentation B.) Physical C.) Transport D.) Application E.) Data-Link F.) Network

2 Answers  

---

What is the default size of a standard ping on a Cisco router? * A: 100 bytes * B: 32 bytes * C: 10 bytes * D: 16 bytes

2 Answers   CMS,

---