Identify the command that disables name-to-address translation? A.) Router(config-dns)# no ip domain-lookup B.) Router(config)# no address translation C.) Router(config)# no ip domain-lookup D.) Router(config)# ip domain-lookup

1 Answers  

---

Which command assigns the login password CISCO on the console terminal line? A. line vty 0 login password cisco B. line console login password cisco C. line login terminal password cisco D. line console 0 login E. line console 0 login password cisco

2 Answers  

---

Identify the command that configures the bandwidth to 56K? A.) Router(config-if)# bandwidth 56000 B.) Router(config-if)# bandwidth 56k C.) Router(config)# bandwidth 56 D.) Router(config-if)# bandwidth 56

1 Answers  

---

Which of the following is an invalid host address using a netmask of 255.255.255.192? A.) 10.1.1.1 B.) 10.1.1.66 C.) 10.1.1.130 D.) 10.1.1.127

2 Answers  

---

What is the Cisco name for the encapsulation type used on a serial interface? A. HDLC B. SDLC C. SAP D. SNAP

3 Answers   HCL,

---

---

If i connect two routers through ethernet cable and serial cable then which has high speed and which is better among two?

10 Answers   Compaq, Inspace, Wipro,

---

When a Distance Vector routing protocol detects that a connected network has gone down, it sends out a special routing update packet, telling all directly connected routers that the distance to the dead network is infinity. This is an example of which routing technology? A.) ICMP. B.) Only Link State routing protocols have this intelligence. C.) Triggered updates. D.) Garrison-4. E.) Split Horizon. F.) Poison Reverse.

1 Answers  

---

What is the most common layer 2 device? A. Hub B. Router C. Switch D. Repeater

7 Answers   CISOC, Wipro,

---

What do the following commands accomplish? access-list 1 permit 172.16.0.0 0.0.255.255 interface ethernet 0 IP access-group 1 out interface ethernet 1 IP access-group 1 out A. Only traffic from the source network 172.16.0.0 will be blocked. B. Only traffic from the source network 172.16.0.0 will be forwarded. Non-172.16.0.0 network traffic is blocked. C. Non-172.16.0.0 traffic will be forwarded. D. All traffic will be forwarded.

1 Answers  

---

Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

1 Answers  

---

1900 Value in which type of access list?

0 Answers  

---

2500 Value in which type of access list?

0 Answers  

---