When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number

1 Answers  

---

Which two statements about integrated services digital network (ISDN) are true? A. ISDN provides data only capability B. ISDN provides an integrated voice/data capability C. The ISDN standards define the hardware and call setup schemes for end the end digital connectivity D. Users receive more bandwidth on WANS with a leased lin of 56 Cops than with multiple B channels

1 Answers  

---

Hello Mr.Jitendera Kuamr Sinha, how is every thing going on? Thanks for your reply. Dear Friend if you can Explain it little bit deeper i will be realy thanks full. Wish you all the Best.

1 Answers  

---

Which OSI Reference Layer controls application to application communication? A.) Datalink B.) Network C.) Transport D.) Session E.) Physical

3 Answers  

---

Which of the following do not belong to the customer? A.) CO B.) DCE C.) Router D.) CPE E.) Demarc F.) DTE

1 Answers  

---

Which memory component on a Cisco router contains the dynamic system configuration? ROM NVRAM Flash RAM/DRAM

17 Answers   HCL, Sun TV,

---

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

1 Answers  

---

What layer can optionally support reliability? A.) Transport B.) IP C.) Physical D.) Network E.) Sub-physical layer

2 Answers  

---

What is the command to allow you to type Tokyo instead of the IP address 172.16.30.1 to access a router named Tokyo? A.) config t, ip host Tokyo 172.16.30.1 B.) config t, ip hostname Tokyo 172.16.30.1 C.) config t, hostname Tokyo 172.16.30.1 D.) config t, ip hostname 172.16.30.1 Tokyo

2 Answers  

---

Why we use filter option?

0 Answers  

---

What is ospf? Describe it.

0 Answers  

---

What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.

1 Answers  

---