There is an emergency fall-back 'skeleton' IOS stored in read only memory on all Cisco routers. What command would make the router load the IOS from Read Only Memory? A.) reload rom B.) boot system rom C.) load ios bootflash D.) load ios rom E.) bootsystem skeleton

3 Answers  

---

Choose three reasons why the networking industry uses a layered model: A.) It facilitates systematic troubleshooting B.) It allows changes in one layer to occur without changing other layers C.) It allows changes to occur in all layers when changing one protocol D.) It clarifies how to do it rather than what general function to be done E.) It clarifies what general function is to be done rather than how to do it

1 Answers  

---

In regards to the OSI seven-layer model, at which layer is EBCDIC and ASCII? A.) Presentation B.) Application C.) Transport D.) Session E.) Datalink F.) Network

1 Answers  

---

friends i have 3ree prob which is asked in ibm india in technical round 1 what is ftp(this was easy i had answered) 2 why we use ftp(i think it is a tough one) 3 how can we enable ftp in the widows xp. friend i need these question answer as soon as possible if it is possible to reply within the eveing then i always obeyliged to you i am espacily looking towards the jitendera sinha who make most of the valuable answer loking toward you nidhi mall

3 Answers   IBM,

---

What is the update period for rip?

0 Answers  

---

What is the regional telco office called, where the customers local loop terminates? A.) Demarc B.) DTE C.) DCE D.) CO E.) CPE

1 Answers  

---

what is the distance betwwen link stae routing protocl and distance vector who have the best convergence toplogy eigrp conatain 3 table name them what the toplogy table contain

5 Answers   IBM,

---

1. What is an advantage to LAN segmentation? A. Provides multiprotocol support B. Decreases security C. Decreases broadcasts D. Increases broadcasts

2 Answers  

---

Which type of switching reads just the address portion of the frame and then immediately starts forwarding it? A.) Cut-Through B.) Store-and-Forward C.) Tabling D.) Routing E.) Inverse ARP F.) Fast Forward

1 Answers  

---

What are two functions of the ICMP protocol? (Choose two) A. to map IP addresses to Ethernet addresses B. to map common names to network addresses C. to forward SNMP alerts to management consoles D. to generate an echo reply in response to a ping test E. to send a host or pod unreachable message from a router to the source of an undeliverable packet

1 Answers  

---

How many types of ospf configuration?

0 Answers  

---

Define autonomous system (as)?

0 Answers  

---