Which is true regarding half duplex Ethernet operation? A.) Half Duplex ethernet technology provides a transmit circuit connection wired directly to the receiver circuit at the other end B.) Half duplex transmission between stations is achieved by using point to multipoint Ethernet and Fast Ethernet C.) With Half Duplex transmission logically circuits feed into a single cable creating a situation similar to a one way bridge D.) Half Duplex transmission between stations is achieved using Point to Point Ethernet & Fast Ethernet

1 Answers  

---

friends i have 3ree prob which is asked in ibm india in technical round 1 what is ftp(this was easy i had answered) 2 why we use ftp(i think it is a tough one) 3 how can we enable ftp in the widows xp. friend i need these question answer as soon as possible if it is possible to reply within the eveing then i always obeyliged to you i am espacily looking towards the jitendera sinha who make most of the valuable answer loking toward you nidhi mall

3 Answers   IBM,

---

Identify the following components of the IPX address 2e.0000.0065.ed43 A.) Not a valid IPX address B.) Network = 2e, Subnet = 0000, Node = 0065.ed43 C.) Network = 2e.0000, Node = 0065.ed43 D.) Network = 2e, Node = 0000.0065.ed43

1 Answers  

---

CCNA question and answer only for networking.

0 Answers  

---

Define logical topology.

0 Answers  

---

Briefly explain the conversion steps in data encapsulation.

0 Answers  

---

Which layer is responsible for putting 1s and 0s into a logical group? A.) Session B.) Application C.) Transport D.) Data Link E.) Physical F.) Network

2 Answers  

---

Which OSI layer performs code conversion, code formatting and encryption? A.) Physical B.) Data-Link C.) Application D.) Transport E.) Presentation F.) Network

1 Answers  

---

Which command will display the IPX routing table? A.) show routes B.) show routes ipx C.) show routes protocol=ipx D.) show ipx E.) show ipx route

1 Answers  

---

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

---

what is difference between subnet-mask and wildcard mask?

6 Answers   IBM,

---

When we use router?

0 Answers  

---