Which layer is responsible for putting 1s and 0s into a logical
group?
A.) Session
B.) Application
C.) Transport
D.) Data Link
E.) Physical
F.) Network
Answers were Sorted based on User's Feedback
Identify the components in the following command 'interface serial0/1/1' A.) Serial interface, port number 0, slot 1, port adapter 1 B.) Serial interface, slot 1, port number 1, port adapter 0 C.) Serial interface, slot 0, port adapter 1, port number 1
When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30
Which command displays access list 111? A. show access-list 111 B. show ip access-list 111 C. display ip access-list 111 D. display access-list 111 details
What is required to support full-duplex Ethernet? A.) Multiple paths between multiple stations on a link B.) Automatic sensing operation by all connected stations C.) Loopback and collision detection disabled D.) Full-duplex NIC cards
Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport
what is ping utility and how to work.
Identify the command to display the configured IP routing protocols? A.) show protocols B.) show protocols all C.) show routing-protocols D.) show ip protocols
Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network
What does 'P' mean when running a Trace? A.) Good route B.) Protocol unreachable C.) Source Quench D.) Destination unreachable
which layer is responsible for flow control with sliding windows and reliability with sequence number and acknowledgement? A)Transport. B)Application C) Internet D)Network Interface
What does eq means?
How do i decide if an extended access-list is in or out?