Answer / narendra garg

Time-to-live

TTL

Which of the following protocols are used to get an IP address from a known MAC address? A.) BootP B.) TCP C.) IP D.) ARP E.) RARP F.) ICMP

1 Answers   CMC,

---

What are the different IPX access lists?

0 Answers  

---

Which protocol is used for booting diskless workstations? A.) IP B.) ARP C.) RARP D.) TCP E.) SNMP

2 Answers  

---

What is Transport and Tunnel mode?

0 Answers   CCIE,

---

how to troubleshoot when protocols is down and link is not getting up

7 Answers   HCL, Sify,

---

tell me our traditional ip routing is what A--conectless b----conection orented c-----pacekt switching d------ckt switching slect any two this is the question which i forgot to incoprate next-questions

4 Answers  

---

Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)

0 Answers  

---

Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash

2 Answers  

---

What is the default CDP broadcast update rate for Cisco routers? A.) 120 seconds B.) 60 seconds C.) 30 seconds D.) 90 seconds

3 Answers  

---

What is the icmp protocol?

0 Answers  

---

Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, the router enters in its table the number 16 to signify destination unreachable

1 Answers   Google,

---

Routers can learn about destinations through static routes, default, or dynamic routing. By default, a router will use information derived from __________. A. IGRP B. RIP C. IP D. TCP

2 Answers   pspl,

---