Which of the following is a characteristic of a switch, but not of a router? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet

1 Answers  

---

whats the routing protocol supporting in both juniper , cisco routers.

10 Answers   HCL,

---

What is a vlan? What does vlan provide?

0 Answers  

---

Which three commands are used to configure information into RAM on a router? (Choose three) A. configure memory B. configure terminal C. configure overwrite D. copy tftp startup-config E. copy running-config startup-config F. copy startup-config running-config

8 Answers   HCL,

---

Which command should you use to confound a router so that it can become a TFTP server host for a router system image that is run in a Flash? A. copy flash tftp B. config tftp server C. write, network -router name- D. tftp-server system -file name- E. setup server tftp -system name-

1 Answers  

---

What is the point-to-point protocol in ccna?

0 Answers  

---

Assuming no subnetting, which two pieces of information can be derived from the IP address 144.132.25.10? (Choose two) A. It is a Class C address B. It is a Class B address C. The network address is 144.0.0.0 D. The network address is 144.132.25.0 E. The host spoon of the address is 25.10

2 Answers  

---

What is a function of a reliable transport layer connection? A. route selection B. acknowledgements C. session checkpoints D. system authentication

2 Answers  

---

Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport

3 Answers  

---

Which configuration mode and command combination sets the bandwidth metric of a Frame Relay connection? A. router(config)# clock rate 56 B. router(config)# bandwidth 56 C. router(config)# bandwidth 56000 D. router(config)# clock rate 56000

2 Answers  

---

How do you disable advanced editing? A.) terminal editing B.) terminal no editing C.) disable editing D.) no terminal editing

1 Answers  

---

Identify the purpose of the TCP 3 step handshake? A.) Setup a un-reliable connection B.) Initialize routing tables C.) Synchronize sequence numbers between hosts D.) Connection tear down process

1 Answers  

---