How many types of ends in wan?
No Answer is Posted For this Question
Be the First to Post Answer
What is difference between flsm and vlsm?
After the command -- router igrp 200 -- what command would enable IGRP on the router for interface E0, with an address of 157.89.4.4 and a mask of 255.255.255.0 ? A.) network 157.89.4.0 255.255.255.1 B.) network 157.89.0.0 C.) router igrp * D.) router igrp 157.89.0.1 E.) router igrp int e1 F.) router igrp 157.89.4.1
What are the ranges of private ips?
Which statement about Ethernet switches is true? A. Symmetric switching allows connection between pods of unlike bandwidth and does not require memory buffering B. Memory Buffering is used to prevent a bottleneck when pods of different bandwidth are connected on a symmetric switch C. The latency can be reduced if the switch utilizes the store and forward method of switching store and forward is better for error detection D. The cut through method of switching is faster because the switch forwards the packet to the destination as soon as it reads the destination address
Which term describes the process in which frames from one network system are placed inside the frames of another network system? A. bridging B. tunnelling C. data link control D. generic routing E. packet switching
If i connect two routers through ethernet cable and serial cable then which has high speed and which is better among two?
10 Answers Compaq, Inspace, Wipro,
A default route is analogous to a _________. A. default gateway B. static route C. dynamic route D. one-way route
What is the default interval for SAP updates? A.) 60 seconds B.) 15 seconds C.) 30 seconds D.) 120 seconds
There is an emergency fall-back 'skeleton' IOS stored in read only memory on all Cisco routers. What command would make the router load the IOS from Read Only Memory? A.) reload rom B.) boot system rom C.) load ios bootflash D.) load ios rom E.) bootsystem skeleton
How convergence happen in ospf?
How we can find ASBR Router, we have no authentication to enter router?
What is the purpose and default value of the CDP timer command? A.) 90 seconds; interval before an entry expires B.) 60 seconds; interval between updates C.) 60 seconds; interval before an entry expires D.) 90 seconds; interval between updates