What is the command to copy the IOS image to a TFTP server? A.) copy flash tftp B.) copy running-config tftp C.) copy ios tftp D.) copy startup-config tftp

2 Answers  

---

In IOS boot sequence if the flash is erased, and there is no access to TFTP server, and we can't load the partial IOS from ROM. Is there any possiblity that we can still boot the router/switch from external PC in which the IOS is installed?

6 Answers  

---

Why ip address called logical address?

0 Answers  

---

You have a Frame Relay link on serial 1. Which command displays the Local Management Interface (LMI) data link connection identifier (DLCI) and bandwidth for that link? A. show interface serial1 B. show frame-felay serial1 C. show protocol frame-relay serial1 D. show serial1 encapsulation frame-relay

1 Answers  

---

Which statement about the flow control function of TCP is true? A. TCP makes no snarl to check for lost or duplicate data packets B. The application layer must sequence data packets when using TCP C. TCP controls the flow of UDP data through negative acknowledgements (NAK) D. TCP is a connection-oriented protocol that acknowledges receipt of data packets and is considered reliable

1 Answers  

---

When setting up a WAN network, everything outside of the Demarc is not owned by the customer. Which of the following are not owned by the customer? A.) The T1 line. B.) LAN C.) The Router D.) DTE E.) PC's F.) CO

1 Answers  

---

Identify the command that displays ethernet0/1 interface status? A.) show interface ethernet0/1 B.) show interface ethernet e0/1 C.) show interface ethernet0.1 D.) show ethernet0/1

3 Answers  

---

What do you mean by Port Mirroring?

0 Answers  

---

Which Cisco IOS command should you use to display the Novell IPX address assignments on a router? A. show ipx addresses B. show ipx interface C. show me the money D. ipx, network (number) E. display ipx addresses F. show ipx routing details

1 Answers  

---

which algorithm as defined by the transform set is used for providing data confidentiality when connected to tyre?

0 Answers  

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

1 Answers  

---

What is the purpose of data link layer?

0 Answers  

---