What would be the first command from global configuration mode to enable RIP on your router for interface E0, with an address of 181.86.4.4 and mask of 255.255.255.0 ? A.) router rip B.) network 181.89.4.0 255.255.255.0 C.) router rip int e0 D.) router rip 181.86.0.0 E.) router rip 181.86.4.0 F.) network 181.86.0.0

1 Answers  

---

Explain the draw back of eigrp protocol?

0 Answers  

---

As a system administrator, you need to set up one Ethernet interface on the Cisco router to allow for both sap and Novell-ether encapsulations. Which set of commands will accomplish this? A. interface ethernet 0.1 ipx encapsulation Novell-ether ipx network 9e interface ethernet 0.2 ipx network 6c B. interface ethernet 0 ipx encapsulation Novell-ether ipx network 9e interface ethernet 0 ipx encapsulation sap ipx network 6c C. interface ethernet 0.1 ipx encapsulation Novell-ether interface ethernet 0.2 ipx encapsulation sap D. interface ethernet 0.1 ipx encapsulation Novell-ether ipx network 9e interface ethernet 0.2 ipx encapsulation sap ipx network 6c

1 Answers  

---

what is the major difference between EIGRP & IGRP?

9 Answers   Wipro,

---

1 what is the number of telnet session in the cisco router a 1 b 2 c 3 d 4 e 5

4 Answers  

---

Which three of the following are true statements about connection-oriented sessions? A.) The segments delivered are acknowledged back to the sender upon their reception B.) Any segments not acknowledged are retransmitted by the receiver C.) A manageable data flow is maintained in order to avoid congestion, overloading and loss of any data D.) Segments are sequenced back into their proper order upon arrival at their destination

3 Answers  

---

What does a metric of 16 hops represent when using RIP? A.) Number of hops to the destination B.) Destination unreachable C.) Number of routers D.) Bandwidth

2 Answers   IBM,

---

Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame

1 Answers  

---

What is the result of segmenting a network with a router into segments 1 and 2? A. It increases the number of collisions B. It decreases the number of broadcast domains C. It connects segment 1 and broadcasts to segment 2 D. It connects segment 1 and broadcasts from genre to segment 2

2 Answers  

---

Which of the following are valid Cisco encapsulation type names? A.) arpa = IPX Ethernet B.) novell-ether = IPX Ethernet_802.3 C.) snap = IEEE 802.2 SNAP on Ethernet, FDDI, and Token Ring D.) novell-fddi = IPX Fddi_Raw E.) sap = IEEE 802.2 on Ethernet, FDDI, and Token Ring F.) hdlc = HDLC on serial interfaces

1 Answers  

---

Of the following switching types, which one has the highest latency? A.) Cut-through B.) None C.) Store-and-forward D.) Fragment Free

1 Answers  

---

What are the different types of password used in securing a cisco router?

0 Answers  

---